A hobbyist known as mkopec turned a Cable Matters USB-C hub costing about $45 into a working Nintendo Switch 2 dock, changing only its firmware. The result is a cheap, compact accessory aimed at travellers who find Nintendo's official dock bulky.

Psst!Add AlexTech.ai asPreferred Source on Google

The change adds about 540 bytes to a firmware of just 32 KiB. The modified firmware answers Nintendo's proprietary messages and returns the same identity as the official dock, which makes TV mode work. With the stock firmware it did not. The hub is a seven-in-one triple-display device built from specialised chips: a VL103 for USB-PD control, a VL817 for the USB ports, an RTD2142 for DisplayPort-to-HDMI conversion, and XT25F16B flash memory. The VL chips come from VIA Labs and the RTD2142 from Realtek. The stock hub reports VIA's vendor ID, which had to be changed.

The work was done in seven incremental versions. The modder captured traffic from the official dock with an inline USB-PD sniffer, dumped the VL103 firmware with the vli plugin of fwupd, the Linux firmware update tool, and reflashed it through the VL817. Changes covered the replies to Nintendo's discovery and mode-entry commands, power delivery at 15 V and 2.8 A like the dock, the vendor ID, and finally a full sequence match that removed a pause of about three seconds.

The result contradicts claims that two accessory makers made to The Verge, that the dock check relies on encryption with a dedicated chip. Here, copied identity data and fixed replies were enough. Nintendo has said it has no intention of hindering legitimate third-party dock compatibility.

A second problem, washed-out colours in HDR over HDMI, was fixed with a 108-byte patch to the RTD2142 firmware, flashed over I2C on the DisplayPort AUX channel. The cause was an AVI InfoFrame signalling BT.709 instead of the wider BT.2020 that HDR requires. A third-party dock's firmware contains a debug string suggesting this is a known issue. HDR through the hub's own DisplayPort port remains washed out. The hub firmware has no variable refresh rate support: with the patch the console offers VRR, but turning it on freezes the DisplayPort picture, and HDMI stays at 60 Hz. The project publishes no code or patch files, and the modder did not rigorously test the USB ports or Ethernet, nor say which Switch 2 system version was used.